9095 MultiCon Analyzer

9096 Degas Cation Conductivity Analyzer

In Stock


The NEW Waltron 9096 Degas Cation Conductivity Analyzer delivers accurate measurement of specific, cation, and degassed cation conductivity with unprecedented degassing efficiency of over 94% in under 90 seconds.

During the start up of a thermal power plant, the purity of the generated steam determines whether it can be sent to the steam turbine or if it has to be bypassed to the condenser. Traditionally “Cation Conductivity” instruments are used to analyze steam quality, but in addition to measuring harmful ionic compounds (e.g. Chlorides), they also include CO2, which is not significantly harmful to the steam turbine.

The Waltron 9096 Degas Cation Conductivity Analyzer is based on a patent-pending “Dynamic System”,  meaning it does not use a reboiler or require any supplemental inert gases.

This instrument uses ambient air forced against the flow of the water sample to achieve its high degassing efficiency, resulting in significantly faster indications than any other comparable systems available.

Based on even the most conservative assumptions, the cost savings on each start-up cycle between the Waltron dynamic system and the fastest reboiler system is significant.  Additional benefits are better energy efficiency and reduced emissions of heat and exhaust.

 Revolutionary heatless degassing technology

 Achieves 93.5% degassing efficiency

 Sample temperature fluctuation does not affect accuracy

 No gas emissions or volatile acids

 One transmitter for three conductivity values and pH

 Alarms for resin exhaustion and low degassing efficiency

 Easy to replace cation column

 Easy to mount stainless steel panel

 Significantly reduced turbine start-up times



0-10µS/cm, 0-100µS/cm

< 0.6% of the measuring range

Reagent Consumption (approximate)
Cation Resin (pre-rinsed) and Soda Lime; replace cartridges every two months

Sensor Classification
Cationic exchange and conductivity sensors

Degassing Efficiency

Data Storage
Extract via USB 2.0

Power Supply
AC 110 to 240 V +10 / -15%; 48 to 63 Hz or AC/DC 20 to 30 V; 48 t0 63 Hz



Sample Temperature Range
32 – 122° F (0 – 50 °C)

Ambient Temperature Range
32 – 140° F (0 – 60 °C)

Inlet Sample Flowrate
.031 – .044 GPM (7-10L/h), 6mm Swagelok

Inlet Sample Pressure
Maximum of 145 psig (10 bar)

Outlet Sample



Analog Outputs
5 x 0/4 – 20 mA for measured signals

General Alarm, Low Degassing Efficiency Alarm, Resin Exhausted Alarm




Transmitter – high strength ABS, IP67
Wet section – stainless steel or PVC

29 x 37 x 10″ (613 x 939 x 254mm)

Wall mount or Panel mount

Corrosion resistant

Đánh giá

Chưa có đánh giá nào.

Hãy là người đầu tiên nhận xét “9096 Degas Cation Conductivity Analyzer”

Email của bạn sẽ không được hiển thị công khai.

Your custom content goes here. You can add the content for individual product
Back to Top